These openers that also came with a multi-function wall control panel instead of the single door bell type button and a multi-button transmitter also has the capability of turning the garage door opener lights on and off after the door is fully opened or closed

Programming Steps:

1) Starting with the door closed, press and hold the transmitter button that you want to use to control the lights. Use a different button from what you use to open and close the door.

2) Press and hold the Light Button (light bulb symbol) on the multi-function control panel while continuing to hold the transmitter button.

3) Press and hold the Lock Button (padlock symbol) on the multi-function control panel while continuing to hold the other two button from above .

4) Once the opener lights flash, release all buttons and the programming should be complete.

  Test the lights by pressing the remote transmitter button that you chose. The opener lights should turn off if they were already on or should turn on if they were already off. Your done!!!